Radyne OM20 Specifications download pdf (Page 21)

DMD1050 Satellite Modem Board Installation

2.6.3 M&C Terminal Setup

The initial field checkout of the modem can also be accomplished from the Terminal Mode. The

Terminal Mode has the advantage of providing full screen access to the modem’s parameters, but

requires a separate terminal or computer running a Terminal Program such as Hyper-terminal and

connection to the applicable pins on the M&C connector J1. The recommended terminal setup is

as follows (These settings can be changed via the Web Browser):

Emulation Type: VT-100

Baud Rate: 19.2 K

Data Bits: 8

Parity: No Parity (Fixed)

Web Browser and Terminal Interfaces Reset

If you cannot access the Web Browser or Terminal interface, reset the

interface defaults. To reset the interface defaults, use the shorting plug

(CNRSHUNT). Obey these steps:

1. Make sure the electrical power to the unit is disconnected.

2. Find the JP5 and JP6 connectors.

3. Find pins 1 and 2 on the JP5 and JP6 connectors.

4. Install the CNRSHUNT shorting plug on pins 1 and 2 of JP5 and pins

1 and 2 of JP6.

5. Connect the electrical power to the unit.

6. This will reset the interface defaults.

See Section 3 for more information.

IMPORTANT

MN-DMD1050 2–5

Revision 9

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 182 183

No comments

Radyne OM20 Specifications Page 21