Radyne OM20 Specifications download pdf (Page 151)

Appendix D. Web Browser

Setup Guide

D.1 Introduction

This section provides quick setup instructions to access the Web Browser through the RJ45

Ethernet interface. The Web user interface allows for complete monitoring and control of all

modem parameters and functions via a 10BaseT Ethernet connection. For more details on the

various WEB configurations and a description of all the available selections, please refer to the

manuals.

D.2 Required Items

� Modem

� RJ45 to RJ45 crossover cable

� Computer

� Default Plug/Jumper if needed for (JP5 & JP6)

D.3 Web Interface Setup Guidelines

D.3.1 Preparing the DMD1050 for Web Setup

The unit is shipped from the factory with the IP addresses pre-configured to an accessible IP

address known as IP TEST MODE (see below). If user has difficulty accessing the Web Browser

interface, then it is recommended that the user install the Default Jumper/Plug that will change

the IP addresses to an accessible address. To reset IP addresses, user must install the Default

Plug between pins 1 & 2 on JP5 and JP6. Jumpers are supplied in the connector kit. This will

change the IP network setting that the user can access.

1. Turn off power to the DMD1050.

2. Install the Reset jumper between pins 1 & 2 of JP5 and JP6 connector. Refer to figure 4-5 for

jumper location.

MN-DMD1050 D–1

Revision 9

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 182 183

No comments

Radyne OM20 Specifications Page 151