Radyne OM20 Specifications Page 19
- Page / 183
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
DMD1050 Satellite Modem Board Installation
2.5.1 Standard DMD1050 Factory Configuration Settings
Implementing Strap Code 26 can set the following modem configuration.
Refer to Table 4-4 for an explanation and tabular listing of available Strap
Codes. The Frequency and Modulator Output Power are set independently of
IMPORTANT
the strap code.
Modulator:
Data Rate: 2.048 Mbps
Mode: Closed Network
Satellite Framing: None
Scrambler: V.35 (IESS)
Inner FEC: 1/2 Rate Viterbi
Outer FEC: Disabled
Modulation: QPSK
Frequency: 950 MHz
Modulator Output Power: -20 dBm
Demodulator:
Data Rate: 2.048 Mbps
Mode: Closed Network
Satellite Framing: None
Scrambler: V.35 (IESS)
Inner FEC: 1/2 Rate Viterbi
Outer FEC: Disabled
Modulation: QPSK
Frequency: 950 MHz
To lock up the modem, enter ‘IF Loopback Enable’ under the Test Menu, or connect a Loopback
Cable from TX port to RX port.
Using the modem’s loopback capabilities with the Ethernet data interface can cause
undesirable network loops. Before you do any data test with an Ethernet interface,
make sure to use two modems connected back-to-back. If you use one modem and a
IMPORTANT
loopback, the results will not be as desired.
MN-DMD1050 2–3
Revision 9
- DMD1050 1
- Table of Contents 5
- PREFACE 11
- Warranty Policy 12
- Limitations of Warranty 12
- Exclusive Remedies 13
- Customer Support 14
- Chapter 1. Introduction 15
- 1.2 DMD1050 Configurations 16
- 1.2.2 Feature Upgrades 16
- 1.3 Function Accessibility 16
- Chapter 2. Installation 17
- 2.2 Unpacking 18
- 2.3 Removal and Assembly 18
- MN-DMD1050 2–3 19
- 2.6 Modulator Checkout 20
- 2.6.1 Initial Power-Up 20
- MN-DMD1050 2–5 21
- 2.7 Storage 22
- 3.1 DMD1050 Hardware 23
- MN-DMD1050 3–2 24
- MN-DMD1050 3–3 25
- 3.2.1 Baseband Processing 26
- MN-DMD1050 3–5 27
- 3.3.2 Terminal Mode Control 28
- MN-DMD1050 3–7 29
- 3.3.6 Terminal Screens 30
- MN-DMD1050 3–10 32
- 3.7.1.6 Ethernet QOS Type 33
- 3.7.1.7 Ethernet QOS Queue 33
- MN-DMD1050 3–12 34
- 3.7.1.9 Packet Statistics 35
- 3.8 Internal Clock 35
- MN-DMD1050 3–15 37
- MN-DMD1050 3–16 38
- 3.10.1 TX Clock Options 39
- 3.10.3 RX SAT Clock 41
- 3.12 Reed-Solomon Codec 42
- 3.12.3 Interleaving 43
- 3.13.1 Radyne AUPC 44
- 3.13.2 EF AUPC 45
- 3.13.3 Near Side AUPC 45
- MN-DMD1050 3–25 47
- MN-DMD1050 3–26 48
- MN-DMD1050 3–27 49
- MN-DMD1050 3–28 50
- 3.17.1 SCC Framing Structure 51
- 3.17.2 Aggregate Data Rate 52
- MN-DMD1050 3–31 53
- Example 1: 54
- Example 2: 54
- MN-DMD1050 3–33 55
- MN-DMD1050 3–34 56
- 3.19 Strap Codes 57
- MN-DMD1050 3–36 58
- 4.1 DMD1050 Connections 59
- MN-DMD1050 4–2 60
- MN-DMD1050 4–3 61
- MN-DMD1050 4–4 62
- MN-DMD1050 4–5 63
- MN-DMD1050 4–6 64
- MN-DMD1050 4–7 65
- MN-DMD1050 4–8 66
- MN-DMD1050 4–9 67
- MN-DMD1050 4–10 68
- CAUTION 69
- 5.2.1 Alarm Faults 70
- 5.2.1.1 Major Tx Alarms 70
- 5.2.1.2 Major Rx Alarms 70
- 5.2.1.3 Minor Tx Alarms 70
- 5.2.1.4 Minor Rx Alarms 71
- 5.2.1.5 Common Major Alarms 71
- 5.2.2 Alarm Masks 71
- Chapter 6. Technical 73
- Specifications 73
- MN-DMD1050 6–2 74
- 6.9.1 Non-DVB 75
- 6.9.2 DVB 76
- MN-DMD1050 6–5 77
- Viterbi 78
- Sequentia 79
- Trellis 81
- Viterbi Decoder 83
- MN-DMD1050 6–12 84
- MN-DMD1050 6–13 85
- MN-DMD1050 6–14 86
- MN-DMD1050 6–15 87
- MN-DMD1050 6–16 88
- MN-DMD1050 6–17 89
- 6.10.11 ACG Output Voltage 90
- Chapter 7. Web Browser 91
- 7.2.1 Appearance 92
- 7.2.2 Navigation 92
- 7.2.3 LED Indicators 93
- 7.3 GUI Screen Menus 94
- 7.3.1 Introduction Menu 95
- 7.3.1.1 Login Screen 96
- 7.3.2 Password Setup 97
- MN-DMD1050 7–8 98
- MN-DMD1050 7–9 99
- MN-DMD1050 7–10 100
- Revision 9 100
- MN-DMD1050 7–11 101
- MN-DMD1050 7–12 102
- Configuring the PC 103
- 7.3.4.1 Transmit Menu 104
- MN-DMD1050 7–15 105
- MN-DMD1050 7–16 106
- MN-DMD1050 7–17 107
- MN-DMD1050 7–18 108
- MN-DMD1050 7–19 109
- MN-DMD1050 7–20 110
- MN-DMD1050 7–21 111
- 7.3.4.2 Receive Menu 112
- MN-DMD1050 7–23 113
- MN-DMD1050 7–24 114
- MN-DMD1050 7–25 115
- MN-DMD1050 7–26 116
- MN-DMD1050 7–27 117
- 7.3.4.3 Interface Menu 118
- MN-DMD1050 7–29 119
- MN-DMD1050 7–30 120
- MN-DMD1050 7–31 121
- MN-DMD1050 7–32 122
- 7.3.4.4 Monitor Menu 123
- MN-DMD1050 7–34 124
- MN-DMD1050 7–35 125
- MN-DMD1050 7–36 126
- 7.3.4.5 Alarms Menu 127
- MN-DMD1050 7–38 128
- MN-DMD1050 129
- MN-DMD1050 7–40 130
- MN-DMD1050 7–41 131
- MN-DMD1050 7–42 132
- MN-DMD1050 7–43 133
- 7.3.4.5.1 System Menu 134
- MN-DMD1050 7–45 135
- MN-DMD1050 7–46 136
- 7.3.4.6 Test Menu 137
- Test Pattern 137
- MN-DMD1050 7–48 138
- A.1 Hardware Options 139
- A.2 Internal High-Stability 139
- A.3 Customized Options 139
- MN-DMD1050 A–2 140
- B.1 States 141
- B.2 Carrier Off 141
- B.3 Carrier On 141
- B.4 Carrier Auto 141
- B.5 Carrier VSat 142
- B.6 Carrier RTS 142
- Appendix C. TCP/IP Ethernet 143
- IMPORTANT 144
- C.4 Ethernet Test 145
- MN-DMD1050 C–4 146
- MN-DMD1050 C–5 147
- MN-DMD1050 C–6 148
- MN-DMD1050 C–7 149
- MN-DMD1050 C–8 150
- Appendix D. Web Browser 151
- Setup Guide 151
- MN-DMD1050 D–2 152
- MN-DMD1050 D–3 153
- D.4.1 Configuring the modem 154
- MN-DMD1050 D–5 155
- MN-DMD1050 D–6 156
- MN-DMD1050 D–7 157
- MN-DMD1050 D–8 158
- Appendix E.User Interface 159
- Connections 159
- MN-DMD1050 E–3 161
- 08-56-0106 162
- Appendix F.Ethernet Data 163
- Interface 163
- MN-DMD1050 F–2 164
- MN-DMD1050 F–3 165
- MN-DMD1050 F–4 166
- Figure F-4 – High Speed Mesh 167
- MN-DMD1050 F–6 168
- MN-DMD1050 F–7 169
- Prioritized Queues 170
- F.8.1 Normal QOS 171
- F.8.2 Port Based QOS 171
- F.8.3 Fair Weighted Queuing 171
- MN-DMD1050 F–10 172
- MN-DMD1050 F–12 174
- Appendix G. DMD1050 Strap 175
- Dis = Disable 176
- Procedure 179
- MN-DMD1050 H–2 180
- MN-DMD1050 H–3 181
- H.8 Monitor and Control 182
- METRIC CONVERSIONS 183
- Units of Length 183
- Temperature Conversions 183
- Units of Weight 183
Related products and manuals for Networking Radyne OM20
Networking Radyne DMD15 Operations Instructions
(201 pages)
(201 pages)
Networking Radyne OM20 Specifications
(212 pages)
(212 pages)
Networking Radyne DMD50 Operations Instructions
(237 pages)
(237 pages)
Networking Radyne OM20 Specifications
(220 pages)
(220 pages)
Networking Radyne MM200 Technical Information
(192 pages)
(192 pages)
Networking Radyne DMD20LBST Specifications
(306 pages)
(306 pages)
Networking Radyne OM20 User Manual
(100 pages)
(100 pages)
Networking Radyne DMD15L Operations Instructions
(118 pages)
(118 pages)
Networking Radyne MM200 User Manual
(34 pages)
(34 pages)
© 2020, manymanuals.com. All rights reserved. | 1.243 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals