Radyne OM20 Specifications Page 20
- Page / 183
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
DMD1050 Satellite Modem Board Installation
IMPORTANT
2.6 Modulator Checkout
The following descriptions assume that the DMD1050 is installed in a suitable location with
clean, stable DC power. Make sure that DC spikes are not present during initial power up.
2.6.1 Initial Power-Up
Make sure that the modem’s input DC power is clean, stable and free of spikes.
If the input DC power is of poor quality, it will damage the unit .
Before connecting power to the unit, disconnect the transmit output from the
operating ground station equipment. Communication traffic can be disrupted
by connecting power to a unit when the configuration settings are not known
and may be incorrect.
New units are shipped with the transmit carrier set to OFF.
The initial field checkout of the modem can be accomplished from the Web Browser or Terminal
Mode. The Web Browser and Terminal Mode has the advantage of providing full screen access
to all of the modem’s parameters, but requires a separate terminal or computer running a
Terminal Program. The modem is configured with the Web Browser enabled.
2.6.2 M&C Web Browser Setup
The Ethernet M&C Interface requires a standard RJ45 Male connector. The Ethernet Interface is
shipped from the factory in an addressable defaulted condition that allows the user to access the
unit. This condition is identified as IP TEST MODE. .
Boot Modes: IPTEST
IP Address Mask: 255.255.255.000
Modem IP Address: 192.168.0.238
Server IP Address: 192.168.000.101
Router IP Address: 192.168.000.102
Refer to section C & D for proper setup of the Ethernet M&C Interface.
Connect an Ethernet cable between the unit and a computer that has web browser capability.
Access the browser and enter the default web address for the unit.
Refer to Section 4
for a complete description of the GUI Interface operation and parameters.
Refer to Appendix C and Appendix D for proper setup of the TCP-IP interface and Web Browser
Setup.
MN-DMD1050 2–4
Revision 9
- DMD1050 1
- Table of Contents 5
- PREFACE 11
- Warranty Policy 12
- Limitations of Warranty 12
- Exclusive Remedies 13
- Customer Support 14
- Chapter 1. Introduction 15
- 1.2 DMD1050 Configurations 16
- 1.2.2 Feature Upgrades 16
- 1.3 Function Accessibility 16
- Chapter 2. Installation 17
- 2.2 Unpacking 18
- 2.3 Removal and Assembly 18
- MN-DMD1050 2–3 19
- 2.6 Modulator Checkout 20
- 2.6.1 Initial Power-Up 20
- MN-DMD1050 2–5 21
- 2.7 Storage 22
- 3.1 DMD1050 Hardware 23
- MN-DMD1050 3–2 24
- MN-DMD1050 3–3 25
- 3.2.1 Baseband Processing 26
- MN-DMD1050 3–5 27
- 3.3.2 Terminal Mode Control 28
- MN-DMD1050 3–7 29
- 3.3.6 Terminal Screens 30
- MN-DMD1050 3–10 32
- 3.7.1.6 Ethernet QOS Type 33
- 3.7.1.7 Ethernet QOS Queue 33
- MN-DMD1050 3–12 34
- 3.7.1.9 Packet Statistics 35
- 3.8 Internal Clock 35
- MN-DMD1050 3–15 37
- MN-DMD1050 3–16 38
- 3.10.1 TX Clock Options 39
- 3.10.3 RX SAT Clock 41
- 3.12 Reed-Solomon Codec 42
- 3.12.3 Interleaving 43
- 3.13.1 Radyne AUPC 44
- 3.13.2 EF AUPC 45
- 3.13.3 Near Side AUPC 45
- MN-DMD1050 3–25 47
- MN-DMD1050 3–26 48
- MN-DMD1050 3–27 49
- MN-DMD1050 3–28 50
- 3.17.1 SCC Framing Structure 51
- 3.17.2 Aggregate Data Rate 52
- MN-DMD1050 3–31 53
- Example 1: 54
- Example 2: 54
- MN-DMD1050 3–33 55
- MN-DMD1050 3–34 56
- 3.19 Strap Codes 57
- MN-DMD1050 3–36 58
- 4.1 DMD1050 Connections 59
- MN-DMD1050 4–2 60
- MN-DMD1050 4–3 61
- MN-DMD1050 4–4 62
- MN-DMD1050 4–5 63
- MN-DMD1050 4–6 64
- MN-DMD1050 4–7 65
- MN-DMD1050 4–8 66
- MN-DMD1050 4–9 67
- MN-DMD1050 4–10 68
- CAUTION 69
- 5.2.1 Alarm Faults 70
- 5.2.1.1 Major Tx Alarms 70
- 5.2.1.2 Major Rx Alarms 70
- 5.2.1.3 Minor Tx Alarms 70
- 5.2.1.4 Minor Rx Alarms 71
- 5.2.1.5 Common Major Alarms 71
- 5.2.2 Alarm Masks 71
- Chapter 6. Technical 73
- Specifications 73
- MN-DMD1050 6–2 74
- 6.9.1 Non-DVB 75
- 6.9.2 DVB 76
- MN-DMD1050 6–5 77
- Viterbi 78
- Sequentia 79
- Trellis 81
- Viterbi Decoder 83
- MN-DMD1050 6–12 84
- MN-DMD1050 6–13 85
- MN-DMD1050 6–14 86
- MN-DMD1050 6–15 87
- MN-DMD1050 6–16 88
- MN-DMD1050 6–17 89
- 6.10.11 ACG Output Voltage 90
- Chapter 7. Web Browser 91
- 7.2.1 Appearance 92
- 7.2.2 Navigation 92
- 7.2.3 LED Indicators 93
- 7.3 GUI Screen Menus 94
- 7.3.1 Introduction Menu 95
- 7.3.1.1 Login Screen 96
- 7.3.2 Password Setup 97
- MN-DMD1050 7–8 98
- MN-DMD1050 7–9 99
- MN-DMD1050 7–10 100
- Revision 9 100
- MN-DMD1050 7–11 101
- MN-DMD1050 7–12 102
- Configuring the PC 103
- 7.3.4.1 Transmit Menu 104
- MN-DMD1050 7–15 105
- MN-DMD1050 7–16 106
- MN-DMD1050 7–17 107
- MN-DMD1050 7–18 108
- MN-DMD1050 7–19 109
- MN-DMD1050 7–20 110
- MN-DMD1050 7–21 111
- 7.3.4.2 Receive Menu 112
- MN-DMD1050 7–23 113
- MN-DMD1050 7–24 114
- MN-DMD1050 7–25 115
- MN-DMD1050 7–26 116
- MN-DMD1050 7–27 117
- 7.3.4.3 Interface Menu 118
- MN-DMD1050 7–29 119
- MN-DMD1050 7–30 120
- MN-DMD1050 7–31 121
- MN-DMD1050 7–32 122
- 7.3.4.4 Monitor Menu 123
- MN-DMD1050 7–34 124
- MN-DMD1050 7–35 125
- MN-DMD1050 7–36 126
- 7.3.4.5 Alarms Menu 127
- MN-DMD1050 7–38 128
- MN-DMD1050 129
- MN-DMD1050 7–40 130
- MN-DMD1050 7–41 131
- MN-DMD1050 7–42 132
- MN-DMD1050 7–43 133
- 7.3.4.5.1 System Menu 134
- MN-DMD1050 7–45 135
- MN-DMD1050 7–46 136
- 7.3.4.6 Test Menu 137
- Test Pattern 137
- MN-DMD1050 7–48 138
- A.1 Hardware Options 139
- A.2 Internal High-Stability 139
- A.3 Customized Options 139
- MN-DMD1050 A–2 140
- B.1 States 141
- B.2 Carrier Off 141
- B.3 Carrier On 141
- B.4 Carrier Auto 141
- B.5 Carrier VSat 142
- B.6 Carrier RTS 142
- Appendix C. TCP/IP Ethernet 143
- IMPORTANT 144
- C.4 Ethernet Test 145
- MN-DMD1050 C–4 146
- MN-DMD1050 C–5 147
- MN-DMD1050 C–6 148
- MN-DMD1050 C–7 149
- MN-DMD1050 C–8 150
- Appendix D. Web Browser 151
- Setup Guide 151
- MN-DMD1050 D–2 152
- MN-DMD1050 D–3 153
- D.4.1 Configuring the modem 154
- MN-DMD1050 D–5 155
- MN-DMD1050 D–6 156
- MN-DMD1050 D–7 157
- MN-DMD1050 D–8 158
- Appendix E.User Interface 159
- Connections 159
- MN-DMD1050 E–3 161
- 08-56-0106 162
- Appendix F.Ethernet Data 163
- Interface 163
- MN-DMD1050 F–2 164
- MN-DMD1050 F–3 165
- MN-DMD1050 F–4 166
- Figure F-4 – High Speed Mesh 167
- MN-DMD1050 F–6 168
- MN-DMD1050 F–7 169
- Prioritized Queues 170
- F.8.1 Normal QOS 171
- F.8.2 Port Based QOS 171
- F.8.3 Fair Weighted Queuing 171
- MN-DMD1050 F–10 172
- MN-DMD1050 F–12 174
- Appendix G. DMD1050 Strap 175
- Dis = Disable 176
- Procedure 179
- MN-DMD1050 H–2 180
- MN-DMD1050 H–3 181
- H.8 Monitor and Control 182
- METRIC CONVERSIONS 183
- Units of Length 183
- Temperature Conversions 183
- Units of Weight 183
Related products and manuals for Networking Radyne OM20
Networking Radyne DMD15 Operations Instructions
(201 pages)
(201 pages)
Networking Radyne OM20 Specifications
(212 pages)
(212 pages)
Networking Radyne DMD50 Operations Instructions
(237 pages)
(237 pages)
Networking Radyne OM20 Specifications
(220 pages)
(220 pages)
Networking Radyne MM200 Technical Information
(192 pages)
(192 pages)
Networking Radyne DMD20LBST Specifications
(306 pages)
(306 pages)
Networking Radyne OM20 User Manual
(100 pages)
(100 pages)
Networking Radyne DMD15L Operations Instructions
(118 pages)
(118 pages)
Networking Radyne MM200 User Manual
(34 pages)
(34 pages)
© 2020, manymanuals.com. All rights reserved. | 0.375 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals