NMS-4000
Network Management System
P/N 2349-72712-01 Page 2-15
Table 2-8: Multiplexers Dialog Parameters
PARAMETER DESCRIPTION
IP Address Changes the IP Address of the computer where the
Multiplexer proxy is running.
Base Port Changes the port number of the Multiplexer proxy.
Should normally be 6661.
Num. Of Port This parameter default value is 15 and should not be
changed.
The proxy uses several communication ports to split
the amount of data between all the ports.
The ports that are being used are all the ports from
[Base Port] to [Base Port + Num. of Port].
The following ports are used in the example above:
6661, 6662, 6663, … , 6675, 6676.
Notification Port This parameter default value is 162 and should not
be changed.
Community Changes the SNMP community. All Multiplexers
types should have the same community name:
rtm3800
The community name is case sensitive.
Notif. Type Selects the type of notifications from the proxy:
Inform or Trap.
This parameter default value is “Trap” and should
usually not be changed.
The Inform notification type is relevant only when
Mux proxy is stand-alone.
Retransmit Policy –
Timeout (sec)
The parameter value should be one of the following:
• 7.5 – for fast redundancy
• 14.5 – for slow redundancy
When Mux proxy is stand-alone, define a proper
timeout value between retransmits.
Retransmit Policy –
Retries
Changes the number of retries.
This parameter default value is 3 and should not be
changed.
Comments to this Manuals