Radyne OM20 Specifications download pdf (Page 37)

OM20 Universal Outdoor Modem OM20 Initial Configuration

MN-OM20– Revision 5 3–5

3.3.2 RX Input Verification Test

Connect a Spectrum Analyzer and Bias-T to the RXRF L-Band Output of the LNB. Ensure that

the Antenna is correctly tuned and that the carrier of interest is visible and that the frequency and

power level is correct. Verify that all the receive parameters of the OM20 are correct. Remove

the LNB coax cable from the Bias-T and connect to the RX L-Band input port J7 on the OM20.

Enable the correct DC Bias Voltage for the LNB from the OM20 Browser. Verify that the OM20

receiver locks to the carrier of interest.

CAUTION

DC Voltage may be present on the output connector.

3.4 Storage and Reshipment

It is recommended that the unit be stored or reshipped in its original sealed packing. The unit

should be stored in a dry location where the temperature is stable, away from direct contact with

rain, snow, wind, sun, or anything that may cause damage.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 219 220

No comments

Radyne OM20 Specifications Page 37