Radyne OM20 Specifications download pdf (Page 169)

OM20 Universal Outdoor Modem Appendix B

MN-OM20– Revision 5 B–3

B.4 Demonstration Procedure

The procedure for enabling a 30-day demo of the OM20 options is similar to the procedure used

for permanently updating the modems feature set. The one big difference being that at the end of

30 days, the demo features will automatically be disabled and the modem will revert back to its

permanent configuration.

At the end of the demonstration period, when the modem reverts back to

its permanent configuration an interrupt in traffic will occur, regardless of

whether or not a demo enabled features was being run at the time. In

addition, operator intervention may be required to restore the data paths.

In order to avoid this interruption in service, the user can cancel the

demonstration at any time by following the instructions outlined in the

section on “Canceling Demonstration Mode.”

1. The following steps allow users to quickly determine from the GUI Interface whether

or not the desired feature(s) are supported by the hardware currently installed in the

modem.

Using the GUI interface navigate to the Features menu under “System” gel-tab. Click on

“features”. This will show the available features and all features checked are the

purchased/installed features.

2. Contact Radyne with the Unit ID and Request a Demonstration. The modem’s Unit

ID can be found in the Terminal interface as follows:

a. From the main menu, the Features menu.

b. “Feature Id: is the unit ID number

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 219 220

No comments

Radyne OM20 Specifications Page 169