Radyne DM240XR Specifications download pdf (Page 169)

DM240XR High-Speed Digital Modulator TCP/IP Ethernet Setup

MN-DM240XR– Revision 13 B–3

set to a foreign address. Broadcast and loop back addresses will not be allowed. Router not used

example: Router IP Address setting: 010.000.001.001.

MODEM EADDR

: This displays the Modem (Unit) Ethernet Address. The Modem Ethernet

Address is configured at the factory. It is a unique Radyne equipment identifier Address.

Example: 0010650903EB

ETHER RATE

B.3 Network Configuration Summary

: This displays the current Ethernet port data rate. If multiple rates are available,

then a selection can be made to specify the Ethernet port data rate (10BaseT). Example Ethernet

port Data Rate: 10 MBPS/HD

If the above steps were followed and the information was entered, then the following would be

the TCP / IP configuration summary for a ‘no router specified’ setup:

1. Boot Mode = NON-VOL

2. Bootp Server Tag = 206

3. Modem Host= DM240

4. IP Address Mask = 255.255.0.0

5. Modem IP Address = 172.18.100.215

6. Server IP Address = 172.18.4.250

7. Router IP Address = 010.000.001.001

8. Modem Ethernet Address= 0010650903EB

9. Ethernet Rate = 10 MBPS/HD

B.4 Ethernet Test

B.4.1 Connecting the Modem Ethernet Cable to a Network Link

1. Connect the Network Switch (Hub) to the Modem Ethernet port (J9) using standard RJ-45

to RJ-45 10BaseT (CAT-5) Cables as shown below.

DM240 Ethernet Network Connection

B.4.2 Connecting the Modem Ethernet Cable Directly to a Computer (without a

Network)

The user can directly connect to the equipment without connecting to a network. This will often

occur at remote sites where a network is not available. To connect, the user will need an Ethernet

Crossover (Null) cable. The pinout for this cable is as follows,

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 195 196

No comments

Radyne DM240XR Specifications Page 169